[Avrora] Energy consumption values
Daniel Garcia Aubert
danielgarciaaubert at gmail.com
Wed Mar 10 03:52:57 PST 2010
I tried your request, but I´ve a new problem. Now I´ve got two applications:
- SensitiveSampler (Read of sensor and send to radio)
- SensitiveBase (Read of radio and sends to UART).
If I test with Avrora I only can test with one application at the same time.
Then, in simulation SensitiveSampler only sends protocol messages without
reply and not works fine. How I can use avrora for two applications at same
Normally I use the following:
avrora -platform=micaz -simulation=sensor-network -nodecount=2 -seconds=60
I would have to indicate: SensitiveBase for NODE_ID=0 and SensitiveSampler
for NODE_ID=1. Or similar something...
Thanks very much Daniel. You help me a lot!
2010/3/10 Daniel Minder <daniel.minder at uni-due.de>
> Hi Daniel,
> I test my application, that looks like MultihopOscilloscope, it use Radio.
>> think for this my application is in Idle mode how lowest state.
> Right! I tried with the original MultihopOscilloscope that comes with
> TinyOS 2.x and got similar results. The only question is now what part of
> the app prevents the processor from going to sleep mode. It might be the
> UART. So, try to compile a separate binary for your base station with UART
> and a separate binary for all others without UART. Do the others enter power
> save mode now?
> Other question: If avrora not model sensor. Why avrora samples sensor
>> consumption? It may take me to error... no?
> Yes... Since I am doing simulations without a sensor board it does not hurt
> me. But feel free to implement :)
> Daniel Minder
> University of Duisburg-Essen, Networked Embedded Systems
> Bismarckstr. 90, 47057 Duisburg, Germany
> Skype: d.minder
> Avrora mailing list
> Avrora at lists.ucla.edu
Daniel García Aubert
Universidad Carlos III de Madrid.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Avrora